Twelve Panel Saliva Drug Test with Saliva Indicator

DIRECTIONS FOR USE

Allow the test device, specimen, and/or controls to reach room temperature (15-30°C) prior to testing. Instruct the donor to not place anything in the mouth including food, drink, gum, tobacco products for at least 10 minutes prior to collection.

Step 1: Bring the pouch to room temperature before opening it. Remove the test device from the sealed pouch and use it as soon as possible.

Step 2: Using the provided collection swab, remove the collector from the sealed pouch, have donor sweep inside of mouth (cheek, gum, tongue) several times, then hold swab in mouth until color on the saturation indicator strip appears in the indicator window of collection swab. Important: Do not bite, suck, or chew on the sponge. Note: If after 7 minutes, color on the saturation indicator has not appeared in the indicator window, proceed with the test below. (See illustration 1)

Step 3: Open the cap and place the test device on a clean and flat surface. Remove the collection sponge from the mouth and insert the sponge first into the screening device until touch the bottom of the saliva cup, pushing the cap until it locked in place of the saliva cup. Keep upright when insert the sponge. (See illustration 2)

Step 4: Test device upright on flat surface and keep upright while test is running. Wait for the colored signal to appear in test results area. Read the results at 10 minutes. Read saliva alcohol pads at 3 minutes.

Note: 1, Once the collection sponge locks in place, the device is airtight, tamper evident, and ready to be disposed or sent to lab for confirmation (on presumptive positive result).

2, In the case of no flowing even with enough saliva specimen, or the saliva is too thick to run, please move the device but don’t tilt and keep upright back and forth on a flat and clean surface for several times. Do not tilt the device when the test is running before reading results.

---

INTERPRETATION OF RESULTS

---

Negative Result NEGATIVE: Two colored bands appear on the membrane. One band appears in the control region (C) and another band appears in the test region (T). Certain lines may appear lighter or thinner than other lines. A line is to be considered a line whether it is faint, light or dark. *NOTE: The shade of red in the test line region (Drug/T) will vary, but it should be considered negative whenever there is even a faint pink line.
Preliminary Positive Result: POSITIVE: Only one colored band appears, in the control region (C). No apparent colored band appears in the test region (T).
Invalid Result: INVALID: Control band fails to appear. Results from any test which has not produced a control band at the specific read time must be discarded. Please review the procedure and repeat with a new test. If the problem persists, discontinue using the kit immediately and contact your local distributor.
The InstaCube Oral Drug Test provides only a qualitative, preliminary analytical result. A secondary analytical method must be used to obtain a confirmed result. Gas chromatography/mass spectrometry (GC/MS) or gas chromatography/tandem mass spectrometry (GC/MS/MS) is the preferred confirmatory method. There is a possibility that technical or procedural errors, as well as other interfering substances in the oral fluid specimen may cause erroneous results. A positive test result does not indicate the concentration of drug in the specimen or the route of administration.